Earthing Product Tester

STEP 1: Set Up The Earthing Product Tester

The batteries for the Earthing Product Tester come already installed. Press down on the “PRESS” button on the tester. You should see the green indicator light flash quickly on and off to show the batteries are working.

Check your wall outlet with an Outlet Checker (not included) to ensure you have a grounded outlet. Next, plug the Safety Adapter (included with this kit) into your grounded wall outlet. If you are using a Ground Rod, connect the metal prong of the Safety Adapter to the end of the Ground Rod cord.

Snap Coil Cord #1 (included with this kit) onto the front of the Product Tester. Plug the other end of Coil Cord #1 into the Safety Adapter.

Snap Coil Cord #2 (included with your Earthing or Ground Therapy product) onto your grounding product. Plug the other end of Coil Cord #2 into the Safety Adapter.

Place the tester onto the product, press the PRESS button, and the green light will appear.

STEP 2: Test The Conductivity Of Your Earthing Product

Direct Testing: Place the Product tester firmly onto the conductive surface of your Earthing or Ground Therapy product. Press and hold down the “PRESS” button on the tester. A solid green light in the indicator window shows that your product is conductive and ready to ground you.

Testing Through a Sheet: Add a drop of water onto your sheet. As a standard sheet is not conductive on its own, this mimics the moisture from our body’s natural perspiration that is created over time and adds conductivity when the sheet comes into contact with it. Next, firmly place the Product Tester against the area where you put the drop of water and press and hold down the “PRESS” button. A solid green light in the indicator window shows that your product is conductive and ready to ground you.

A great tip to perform an accurate test is to place either your hand or a solid, flat surface, such as a book, underneath the mat itself to ensure that you can achieve full contact across the sensor plate of the tester and use a decent amount of pressure to mimic our body weight pressing into the bed.

You can also test yourself for grounding when you are in bed using the following steps:

1. Place your plugged-in tester on your nightstand
2. Go to bed wearing only a t-shirt and underpants
3. Wait for 5 minutes
4. After 5 minutes, take the tester and ONLY test your index finger
5. If your index finger is testing green, your whole body is grounded